RT-100
   Beautifully machined idler gears for Aurora T-Jet, Johnny Lightning, Model Motoring, or AFX non magnatraction HO slot cars. Original unused Aurora parts. Modified by milling out 4 pockets with a CNC machining center. The result is a part that weighs about 1/2 as much as a stock one. This will improve acceleration and because this part is located so high on the chassis it will also lower the center of gravity.
                               
RT-159
CNC MACHINED T-JET 9 TOOTH DRIVE PINION
PRECISION CNC MACHINED FROM SOLID STOCK
FRAY & QCQ APPROVED
 

RT-185
NEW NARROW FRONT ENDS!
O-Ring independent brass front end for Aurora T-Jet and Johnny Lightning HO slot cars.
CNC machined brass wheels CNC machined delrin retainers.
0.0635 diameter HARDENED DRILL BLANK AXLE. Axle not cut to length. Mounted tire diameter .325" Width 1.085
 

RT-255D
Low & wide Fray style O-Ring independent delrin front end for Aurora T-Jet and Johnny Lightning HO slot cars.
Same as the RT-255 listed above except the wheels are made from Delrin Weight 1.0 gram.
 

RT-300
Armature pinion gear & wheel puller for Aurora T-Jet, AFX , Johnny Lightning, & Model Motoring HO slot cars. Every racer needs one of these in his pits!

RT-500
IDLER POST EXPANDING TOOL - TAKES THE SLOP OUT OF THE POST TO GEAR FIT
 

RT-550
Aurora T-Jet Gear plate accurately locates on 4 holes in the tool base plate. Spring loaded ball plunger automatically locks the press pivot arm precisely into 3 positions. Tool will perform the following functions with minimal damage to the gears or shafts. 1. Press driven gear from cluster gear shaft. 2. Press drive pinion gear from cluster gear shaft. 3. Press wheels or front end retainers from axles. 4. Press armature pinion gear from armature shaft. (may warp gear plate, I recommend the RT-300 gear puller for this job). Precise high quality components. Press arm and base plate are CNC machined from solid steel. This tool is easy to use & gets the job done FAST like a pit tool should!

Home